PRENTOX ROTENONE FISH TOXICANT POWDER
CENTRAL GARDEN & PET COMPANY · Rotenone 8.74%; Cube Resins other than rotenone 13.11% · EPA Reg 89459-32 · POISON, SINGLE DOSE
Document last checked 2022-05-20
About this product
Active ingredient
Rotenone 8.74%; Cube Resins other than rotenone 13.11%
Manufacturer
CENTRAL GARDEN & PET COMPANY
Category
POISON, SINGLE DOSE
Full details for PRENTOX ROTENONE FISH TOXICANT POWDER
Applicator discussion
Nothing here is label direction — the label is the law.
These are notes from other applicators, moderated before they appear.
Check the labeling accompanying the product and applicable state requirements.
According to the label From the product label
These details were extracted from this product's label PDF.
The label is the law.
Confirm every rate, site, restriction and safety requirement against the label before mixing or applying.
Check for a
state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below.
·
EPA registration data for Reg. 89459-32 →
This product is a rotenone powder fish toxicant containing 5% active rotenone. It is used to control fish in outdoor standing water, including springs, seeps, and areas with poor water exchange. Application involves mixing the powder with water to create a 1% to 5% w/w concentration, or creating a dough-like consistency by mixing the powder with sand and unflavored gelatin.
Pests covered (3)
FISHCARPBULLHEADS
Areas treatable (4)
standing waterLAKES (WATER TREATMENT)PONDS (FISH) (WATER TREATMENT)STREAMS (WATER TREATMENT)
How to treat each type of area 6
standing water
Normal
| Location |
Rate |
Unit |
Dilution |
Label notes |
| Outdoor |
0.74 to 0.37 |
AF Per Pound Product (5% A.I.) |
0.5 – 1.0 ppm Active Rotenone |
Adjust amount of product according to the actual rotenone content on Ingredient Statement on label. |
| Outdoor |
2000 to 1000 |
m3 per Kilogram Product (5% A.I.) |
0.5 – 1.0 ppm Active Rotenone |
Adjust amount of product according to the actual rotenone content on Ingredient Statement on label. |
Tolerant Species
| Location |
Rate |
Unit |
Dilution |
Label notes |
| Outdoor |
0.37 to 0.123 |
AF Per Pound Product (5% A.I.) |
1.0 – 3.0 ppm Active Rotenone |
Adjust amount of product according to the actual rotenone content on Ingredient Statement on label. |
| Outdoor |
1000 to 333 |
m3 per Kilogram Product (5% A.I.) |
1.0 – 3.0 ppm Active Rotenone |
Adjust amount of product according to the actual rotenone content on Ingredient Statement on label. |
Tolerant Species in Organic Ponds
| Location |
Rate |
Unit |
Dilution |
Label notes |
| Outdoor |
0.185 to 0.093 |
AF Per Pound Product (5% A.I.) |
2.0 – 4.0 ppm Active Rotenone |
Adjust amount of product according to the actual rotenone content on Ingredient Statement on label. |
| Outdoor |
500 to 250 |
m3 per Kilogram Product (5% A.I.) |
2.0 – 4.0 ppm Active Rotenone |
Adjust amount of product according to the actual rotenone content on Ingredient Statement on label. |
Mixing instructions 2
| Location |
Amount |
Per |
Finished strength |
Label notes |
|
1 to 5% |
w/w powder to water |
|
Using the semi-closed aspirator system, pre-mix at approximately 1 to 5% w/w powder to water. |
| Springs, Seeps and Areas With Poor Water Exchange |
one pound (0.454 kg) of powdered rotenone to one pound (0.454 kg) of fine to medium washed sand to 2 ounces (0.0567 kg) of unflavored gelatin |
1:1:0.0125 |
dough-like consistency |
add sufficient water to create a dough-like consistency. Keep mixture moist by storing in a sealed container. Only use when in a dough like consistency to insure efficacy. |
Timing & weather
- treat within 48 hours to avoid deactivation (detoxification)
- Water treated with this product will deactivate under natural conditions within one week to one month depending upon temperatures, alkalinity, etc.
- Typically, wait 2 to 4 weeks after treatment prior to restocking.