CHIPCO 26019T FUNGICIDE

ENVIRONMENTAL SCIENCE U.S., LLC · Iprodione 23.1%; Trifloxystrobin 1.44% · EPA Reg 101563-421 · FUNGICIDE Document last checked 2021-05-06

About this product

Active ingredient Iprodione 23.1%; Trifloxystrobin 1.44%

Manufacturer ENVIRONMENTAL SCIENCE U.S., LLC

Category FUNGICIDE

Full details for CHIPCO 26019T FUNGICIDE

EPA registration data Reg. 101563-421 — registry reference, signal word and status.

Applicator discussion

Nothing here is label direction — the label is the law. These are notes from other applicators, moderated before they appear. Check the labeling accompanying the product and applicable state requirements.

Add your experience

Sign in through the portal or Create a free account to post. Comments are reviewed before they appear. Need a website for your pest-control business? See site plans.

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 101563-421 →

Interface Stressgard is a Group 2 | 11 fungicide designed to enhance the color and density of turfgrass while providing protection against stress and controlling various turfgrass diseases. The active ingredients are triadimefon-N (23.53%) and tribuzole (1.44%). It is used on turfgrass to control diseases such as Brown Patch, Dollar Spot, Snow Mold, Fusarium Blight, Pythium Blight, and Curvularia Leaf Spot. Applications are intended for outdoor turfgrass areas. The product can be applied as a foliar spray or through irrigation. When applying, avoid drift to non-target areas like water bodies or residential lawns. Users should follow specific mixing instructions based on the target disease and use appropriate PPE, including long-sleeved shirts, long pants, and chemical-resistant gloves. Note that the product is not registered for use in California to control certain diseases. Always follow the specific rate and dilution instructions provided in the turf direction section for the specific disease being targeted.

Pests covered (22)

Brown PatchDollar SpotSnow MoldFusarium BlightPythium BlightLarge PatchCurvularia Leaf SpotLEAF SPOT (BIPOLARIS)LEAF SPOT (HELMINTHOSPORIUM)NECROTIC RING SPOT (LEPTOSPHAERIA)ANTHRACNOSE (COLLETOTRICUM)MELTING OUT (DRECHSLERA POAE)BROWN PATCH (RHIZOCTONIA)LARGE PATCH (RHIZOCTONIA)MELTING-OUT (HELMINTHOSPORIUM)PINK PATCH (CORTICIUM)RED THREAD (PINK PATCH) (CORTICIUM FUCIFORME)FUSARIUM PATCH (PINK SNOW MOLD) (FUSARIUM NIVALE)GRAY SNOWMOLD (TYPHULA BLIGHT)RUSTDOLLAR SPOT (SCLEROTINIA)CURVULARIA

Areas treatable (8)

TurfgrassORNAMENTAL TURF (GOLF COURSES) (FOLIAR TREATMENT)ORNAMENTAL TURF (GOLF FAIRWAYS) (FOLIAR TREATMENT)ORNAMENTAL TURF (GOLF GREENS) (FOLIAR TREATMENT)ORNAMENTAL TURF (GOLF TEES) (FOLIAR TREATMENT)TANK MIXORNAMENTAL TURF (GROWN FOR SOD)ORNAMENTAL TURF (FOLIAR TREATMENT)

How to treat each type of area 7

Turfgrass

Target pest	Location	Rate	Unit	Dilution	Label notes
Brown Patch	Outdoor	3 to 5	fl oz/1,000 sq ft		Repeat at 14 to 21 day interval as long as needed.
Dollar Spot	Outdoor	3 to 5	fl oz/1,000 sq ft		Repeat at 14 to 21 day interval as long as needed.
Snow Mold	Outdoor	0.5 to 5	gallons of water/1,000 sq ft	0.5 to 5 fl oz per 1,000 sq ft	Apply with sufficient water to ensure coverage. Do not allow spray to stand for longer than 2 hours.
Fusarium Blight	Outdoor	4 to 7	fl oz/1,000 sq ft		Repeat at 14 to 21 day interval as long as needed.
Pythium Blight	Outdoor	4 to 7	fl oz/1,000 sq ft		Repeat at 14 to 21 day interval as long as needed.
Large Patch	Outdoor	4	fl oz/1,000 sq ft		Make first application when conditions are favorable; repeat as necessary.
Curvularia Leaf Spot	Outdoor	4 to 7	fl oz/1,000 sq ft		Repeat at 14 to 21 day interval as long as needed.

Mixing instructions 1

For pests	Location	Label notes
General Turfgrass	Outdoor	Use 0.5 to 5 gallons of water per 1,000 sq ft for foliar spray.

Worker safety

Re-entry interval (REI) 24

PPE required Long-sleeved shirt and long pants; chemical-resistant gloves (barrier type, nitrile, butyl, or neoprene); protective eyewear (goggles or face shield) if handling concentrated product.

Timing & weather

Do not allow spray mixture to stand for longer than 2 hours.
Avoid application if rain is expected shortly after application.

Use restrictions 5

Not registered for use in California to control certain diseases.
Do not apply to areas where water enters treated areas within the restricted entry interval.
Do not apply to residential lawns or non-target areas.
Do not exceed 6 fl oz of product per 1,000 sq ft in a single application.
Do not exceed 3 fl oz of product per 1,000 sq ft per year with a maximum of 6 applications.